Where is the daytime running light module located?

Where is the daytime running light module located?

Typically, the daytime running light module is located under the dash or in the engine compartment.

How do you turn off the DRL on a Ford Explorer?

How to Turn Off Daytime Running Lights On a Ford Explorer

1. Use your information display screen.
2. Use your five-way control switch, located on the left side of your steering wheel.
3. Scroll to settings, vehicle, lighting.
4. Scroll to daytime running lights.

What is a DRL control module?

Daytime running lights are a safety feature found on many late model vehicles. The daytime running lamp module is the computer that controls the daytime running lamps, and any issues with the module can cause the lamps to not function properly.

How do you test a DRL module?

Diagnose the DRL relay daylight hours with parking brake OFF and transmission in drive, remove the DRL relay from the socket and use your voltmeter to check for battery voltage on one terminal in the relay socket and partial voltage in another terminal. Then check for good ground on the other two terminals.

How do you turn off daytime running lights?

If your vehicle is equipped with a “DRL OFF” setting, they can be turned off by twisting the headlight control knob to “DRL OFF.”

How do I test my daytime running light module?

What is a DRL module?

The daytime running lamp module automatically turns on your daytime running lights (DRLs). These lights are less intense than your headlights and make it easier for others to see you in the snow, rain, fog, and other inclement weather conditions. Once the module receives this signal, your DRLs turn on.

Why did my daytime running lights stop working?

If One DRL Is Working, Check the Bulb, Socket, and Switch If only one daytime running light is not working, it most likely has a burnt out bulb or a bad switch. Remove socket from the light and see if the bulb is dark or if the filament is burned out, which means it needs to be replaced.

What fuse is for daytime running lights?

It’s a regular 30 AMP fuse that powers the transfer case encoder motor and the shift control module.

What are the running lights on a 2002 Ford Explorer?

Daytime running lights, sometimes referred to as DRLs or DTRs, are lights that switch on automatically when your 2002 Ford Explorer is turned on and in drive. Since the daytime running lights are on whenever you are driving your Explorer, they are often the first bulbs to burn out.

How to enable or disable Ford daytime running lights?

This is accomplished by inserting a DRL resistor in series with the low beam filaments. When the headlamp switch is engaged, the daytime running lamp function is disabled and the low beam filaments receive 100% system voltage.

What happens when you change the running light on an explorer?

When you change the daytime running light on your Explorer, it is important not touch the glass part of the bulb with your fingers because the oil from your fingertips will cause that part of the bulb to burn hotter, which significantly shortens the life of the bulb.

Where is the DRL relay block located on a Ford truck?

The DRL Resistor (or where it’s supposed to be) is located in the front of the truck. Click for Diagrams The DRL Relay Block is located just under the top of the passenger side dash.