Table of Contents
How do you remove the rear axle on a Ford f150?
How Do I Remove the Rear Axle Bearing on a Ford F-150?
- Place the wheel chocks behind the front wheels of the truck and kick them forward to make them sit snugly against the wheels.
- Place the truck into neutral.
- Remove the two 10 mm bolts that hold the calipers to the brakes.
How long does it take to remove rear axle?
How long does it take to replace a rear axle? If the axle, flange gasket, wheel bearings, brakes, wheel seal, and gear oil was replaced, then the time is 3.75 hours, which is 3 hours and 45 minutes, unless there was an issue with the axle being stuck in the axle housing or the s-cams needed new bushings.
How do you remove a rear axle bearing without a puller?
Steps to take if you want to know how to remove bearing from the shaft without a puller
- Select the right surface.
- Apply the vehicle’s parking brake.
- Use a car jack to raise your vehicle.
- Place jack stands under your vehicle.
- Remove the coverings and trays that are in the way.
- Remove the tires.
What is the rear axle assembly?
A rear axle assembly is a very large and heavy piece of steel and iron that is used to propel the vehicle by converting rotational force into linear motion. That assembly uses a ring and pinion gear set to convert the rotational power to linear motion, by turning the axles, tires and wheels.
How much does an axle cost?
The cost to repair an axle runs between about $500 and $600 dollars before taxes and fees. Costs vary depending the type of vehicle, brand, make, and model. Labor costs vary from between about $50 dollars and $140 depending on how long the job takes for a model of vehicle.
How much is a rear axle replacement?
The cost of fixing a car axle depends on the type of car you drive as well as whether you need to repair the front or rear axle. Most drivers find they need to spend anywhere between $450 and $750 on this essential service.
How do you remove the rear axle on a Ford F-150?
Slide the pinion shaft out toward you and remove it. Push the wheel flanges straight in. Remove the C-clips of the flanges and pull the rear axle shaft straight out of its housing. Reinstall the pinion shaft and replace the pinion shaft retaining bolt; turn it a few turns to prevent the gears from moving.
Where is the rear differential on a Ford F-150?
This article applies to the Ford F-150 (2004-2014) and F-250, F-350 Super Duty (2005-2014). The rear differential is located within the rear axle and is the final step for power to reach the rear wheels. Most vehicles will come with an open differential in the rear which allows for one wheel to spin completely independently of the other.
Can a rear axle be removed from a car?
You have a couple of options when servicing the rear axle. You can do all the work with the axle installed in the car or remove the axle from the car and perform the work on an axle fixture. Each method has advantages and disadvantages. Are you working on a vehicle hoist or using a floor jack and jack stands?
Why are rear axle bearings on a Ford F-150?
Rear axle wheel bearings are a part of the F-150’s suspension. The bearings allow the wheels to rotate while supporting the vehicle’s weight. The constant weight load on the bearings can degrade the seals. A faulty seal can allow dirt, water and other contaminants to enter into the bearings and the grease to leak out.